Water pumps dead

This shows that there is no power that goes into the water pump. The first steps are to check the source of the Stop The electricity can contact or switch. If the input voltage, check Switch Water level in the water storage (if using Water Level Sensor). The next check in Automatic Pressure Switch for water pump that does not use water Tandon alias faucet is opened the pump is on, tap on the pump cover off.
If the terminal voltage up to the water pump but the pump motor does not live and no sound at all can be ascertained from the water pump broke spull or Thermal Switches that are in spull water pump broke. Or it could be spull been burned by the conditions in which the wire has been broken. Because usually when burning but do not drop effect will make our home electrical MCB Trip due to a short-circuit.
For the record checks should not be used because it was detected only Testpen Phasenya alone while its neutral .And not tespen were sometimes lit because the induced voltage.