Wednesday, September 3, 2014

The water pump turns on but the water would not rise.

Although the pump is full of water in the blog but do not want to be sucked up water, it can even happen on a new water pump. and only in pairs. The cause of this problem because there is a hole, although only for a needle in a blog network of suction pipe to the pump, so that air is sucked into the pump go in the water.

Mechanical Seals can be due to the already weak or uneven tiles (wear out) or it could be due at the time of gluing pipe is not perfect so the air coming in through the connection. Also be on the installation of a lot less pretentious threaded his Seal tape.

For the installation of a new pump installed good before tighten the bolts on the pump bolts again because sometimes the installation of the plant is less tight. To damage the water pump of the type of jet pump in addition to the damage mentioned above there are any special damage which sometimes is very requires precision and flair we as a handyman service to fix it.

1 comment:

  1. Thank you for sharing this informative blog post about pumps! I truly appreciate the insights you've provided.

    Centrifugal Chemical Pump Manufacturer

    ReplyDelete