Wednesday, September 3, 2014
Know Your Water Damage Pump
There are many causes of damage to your water pump, to fix it we need to identify or recognize the damage the water pump, among others;
1 Motor / Pump dynamo can not be operated
The causes include:
- Misrepresentation at the time of installing the plug
Fit a way to fix the plug correctly
- Thermal Protector
If the motor is too hot, the motor can not be operated.
Wait until cool (20-30 minutes)
- The plug broke
Replace with new
- Damage to the motor
Repair or replace it with a new
- Source voltage is too small Ask PLN
2 Motor operates but does not pump
The causes include:
- The depth of the well water is lower than the standard depth
Check the depth of your well
- Air is sucked into the suction pipe
After checking pipe connections, connect to the meeting
- Air is sucked into pump through mechanical seal
Replace with a new Mechanical Seal
3 Thermal Protector stops the motor quickly
The causes include:
- Source voltage is too low or vice versa
Search for information / ask PLN
- Impeller attached to another component
Fix the damage
- There was a brief relationship with Capacitor
Fix the damage
4 Water does not come out immediately after the pump is turned on
The causes include:
- Air is sucked into the suction pipe
Fix the damage
5. pump operates though unused water
The causes include:
- Water leaking at pipe joints or pump
Fix connection, pump parts, valves etc.
- Water leak in Mechanical seals
Replace Mechanical seals
- Check Valve does not close tightly
Clean the check valve is
Subscribe to:
Post Comments (Atom)
Thank you for sharing the blog post about pumps! I appreciate the insights provided.
ReplyDeleteCentrifugal Multi Stage Pump Manufacturer
Vertical Centrifugal Pump Manufacturer